Wednesday, 13 February 2013

Day 3- Joining the hull and deck

It's not the most glamorous of tasks, and you do tend to get epoxy all over everything, but it is the part of the build that makes the boat...well look like a boat.


All the joins were roughened top and bottom before the two parts were taped into place. Then a generous bead of fibreballs was put into the joint before a layer of tape was applied over it all.
With one side down it just the opposite and transom to go, before the bulkheads are put into place along with everything else.

 
Martin
 
Previously:
The N2 build continues
Was going well until...
Prestwich Models trim tabs
LMRacing N2
The new LMRacing N2 7.5cc